Hi, Anyone come up with a tool to pull the brake pad setting pins? The two longer pins on the right.:

In the past I've driven out the one at the non-looped end of the spring with a punch. But was wondering if there's a tool that could pull the pin out as it obviously has a place to grasp it.
best regards J.Jefferies

I just use a small drift. However you could modify a pair of pliers or vice grips with a bit of grinding.
Regards Martin.

They do have a special tool https://www.fcpeuro.com/products/brake-caliper-pin-bolt-remover-otc-7302-2 But I'll stick to the drift.
Regards Martin.

For only $123!  Think I'll get two.

I'll just do what I have always done. Use a pair of pliers!

Old school British know how

MartinW wrote:They do have a special tool https://www.fcpeuro.com/products/brake-caliper-pin-bolt-remover-otc-7302-2

The forked side can be used to remove ticks, should the occasion arise.

MartinW wrote:They do have a special tool https://www.fcpeuro.com/products/brake-caliper-pin-bolt-remover-otc-7302-2 But I'll stick to the drift.
Regards Martin.

Hmm, wonder how difficult it would be to make one? Oooh, a new project.

Point-Seven-five wrote:For only $123!  Think I'll get two.

You got the price wrong. Its $123.99 e.g. $124.
Can't afford it.

jjefferies wrote:

Point-Seven-five wrote:For only $123!  Think I'll get two.

You got the price wrong. Its $123.99 e.g. $124.
Can't afford it.

Darn!  I can only afford one.

jjefferies wrote:

MartinW wrote:They do have a special tool https://www.fcpeuro.com/products/brake-caliper-pin-bolt-remover-otc-7302-2 

Hmm, wonder how difficult it would be to make one? Oooh, a new project.

Here it is in action. Video yourself in action with your prototype.   

To beat the FLAT RATE. Right On! Right On!

I'm with Martin as a punch man. Cheap and you can't lose them as any old bit of round steel bar will do!